P2B63
Coolant Pump B Stuck/Stalled
P2B63 means coolant pump B is powered and commanded but its rotor does not turn, or stays far below target speed. Brushless auxiliary pumps notice this themselves, for example from high current without rotation, and report it to the engine computer. Ford lists the code in its 2024 gasoline OBD summary as failure type 71 (actuator stuck) of pump B, base code P261A, checked continuously above 11 V battery voltage. Causes are a seized bearing, debris or deposits jamming the impeller, a pump frozen in a weak antifreeze mix, or an internally failed motor. GM's patent US20160047374A1 explains how comparing measured current and speed against expected values exposes such a pump fault. P2B65 signals the opposite case, too little load. Pump D has the twin code P2B6A.
Possible causes
- Bearing seized or impeller jammed by debris or deposits high
- Electric motor or electronics inside the pump failed medium
- Coolant frozen in the pump because antifreeze concentration is too low low
Symptoms
- Warning lamp with stored code
- No audible pump run after the ignition is switched on
- Overheating of the component served by pump B
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B63
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.