P2B5E
Engine Coolant Flow Control Valve Position Sensor Circuit Low
P2B5E reports a position sensor reading below its valid window. On GM's 3.0-litre Duramax the valve sends its angle as a raw SENT value in percent of 5 V; anything under 2 % counts as too low, and 80 failures in 100 samples at 6.25 ms set a Type B fault, provided there is no SENT communication fault and the relay supplies more than 11 V. A broken 5 V reference, a sensor ground issue inside the valve or a damaged signal wire can produce such a value. GM includes P2B5E in the LM2 chafed-harness condition of bulletin 21-NA-149. The engine computer loses the actual position and stops closed-loop control of coolant flow. High reading: P2B5F; plausibility: P2B60.
Possible causes
- 5 V reference or signal wire interrupted or shorted to ground high
- Chafed engine harness on GM LM2 (21-NA-149) medium
- Position sensor in the valve faulty low
Symptoms
- MIL on after two drives
- Coolant flow no longer regulated, warm-up slower
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B5E
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.