P2B57
Low Engine Oil Pressure - Camshaft Control Disabled
P2B57 is a status code rather than a circuit fault: the engine control has measured or calculated oil pressure too low for safe camshaft adjustment and has therefore switched the cam control off. Hydraulic cam phasers and oil-operated lift switching need a minimum pressure to hold position; below it the parts would rattle or drift. No manufacturer documents the code publicly; NTN-SNR lists it as camshaft timing deactivated because of low oil pressure, and CARB (e)(13) asks for monitoring of valve timing systems. Low oil level, wrong viscosity, a clogged pickup or a weak oil pump are the usual reasons, and a faulty pressure sensor can mimic them. Check pressure first: P0520–P0524 and P06DD/P06DE point to the sensor or pump control.
Possible causes
- Oil level too low or oil of the wrong viscosity high
- Worn oil pump, faulty pump control or clogged pickup screen medium
- Oil pressure sensor reading too low although pressure is fine medium
- Worn bearings causing internal oil leakage at high temperature low
Symptoms
- Check engine light on, often together with an oil pressure warning
- Camshaft adjustment inactive, weaker low-end torque and rough idle
- Rattle from the cam phasers at start or when hot
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2B57
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.