P2B54
A Camshaft Profile Actuator B Control Stuck On Bank 2
With P2B54 actuator B, the second shifter on the bank 2 intake camshaft, is reported as stuck on, meaning its pin or valve stays engaged after the command to release. A public manufacturer description of this exact code was not found. GM's L3B tables show how the bank 1 twin, P2B53, is judged: the Hall feedback must return to the retracted level within the engine cycle, otherwise a stuck pin is assumed. NTN-SNR describes P2B54 as component permanently active, and CARB requires valve control faults of this kind to be detected under (e)(13). On a V-engine only one bank would then run the wrong intake lift, which can cause uneven running between banks. Bank 1: P2B53; stuck off: P2B50.
Possible causes
- Actuator B on the bank 2 intake camshaft stays engaged (sticking plunger) high
- Control line shorted so the solenoid remains energised medium
- Position feedback of the actuator stuck at the engaged value low
Symptoms
- Check engine light on
- Uneven running between the banks, especially at part load
- Profile switching disabled by the engine control
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B54
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.