P2B50
A Camshaft Profile Actuator B Control Performance/Stuck Off Bank 2
Bank 2 of a V-engine has its own intake camshaft (A), and P2B50 reports that the second profile actuator on it does not do its job or stays in the off position. Mercedes-Benz documents the code for the M176 and M177 V8 with CAMTRONIC (for example AMG C63, GLC63 and S 580 models): in topic LI05.20-P-080192 of January 2026, solenoid 2 for the intake side of bank 2 is described as faulty or jammed off, with fault type 07 for a mechanical and 09 for a component fault. Mercedes recommends an engine ECU software update, newer actuator part numbers and an inspection of the harness near the bulkhead, where heat can damage it. The intake lift then cannot switch on that bank. Bank 1 counterpart: P2B4F; stuck on: P2B54.
Possible causes
- CAMTRONIC actuator of an older part number, superseded by Mercedes high
- Engine control software that needs the available update medium
- Harness heat-damaged above the bulkhead near the windscreen medium
- Actuator pin mechanically jammed in the retracted position low
Symptoms
- Check engine light on
- CAMTRONIC lift switching inactive on bank 2, possibly limp-home mode of the system
- Slightly uneven running or higher fuel use at part load
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B50
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.