P2B4D
B Camshaft Position Actuator Position Sensor B Circuit Low Bank 2
A too-low signal from position sensor B at the bank 2 exhaust camshaft actuator sets P2B4D. In practice this is a signal wire touching ground, a shorted sensor, or a sensor that gets no supply. The closest documented case is P34C2 on Mercedes M176/M177 V8s, where solenoid 1 on the bank 2 exhaust side reports a sensor short to ground; P2B4D is not described by any manufacturer in public. That bulletin also points at heat-damaged wiring near the windshield, so inspect the harness on the bank 2 side behind the engine. Repairs range from a wire splice to a new actuator with integrated sensor. CARB requires low-signal faults of such sensors to be recognised. Exhaust high fault on bank 2: P2B4E.
Possible causes
- Signal wire touching ground (heat or chafe damage) high
- Sensor in the actuator shorted medium
- No supply to the sensor low
Symptoms
- Check engine light on
- Exhaust lift change on bank 2 out of action
- Possibly limp-home message of the lift system
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B4D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.