P2B4C
B Camshaft Position Actuator Position Sensor B Range/Performance Bank 2
P2B4C stands for an implausible but electrically valid signal from the B sensor watching the exhaust actuator of bank 2. It is the exhaust-side mirror of P2B44, which Mercedes-Benz documents on CAMTRONIC V8s (M176/M177) for intake solenoid 2 of bank 2; for P2B4C itself there is no public manufacturer text. In the same bulletin Mercedes reports the exhaust sensor of solenoid 1 on bank 2 as P34C1 and points to engine software and revised actuator part numbers. CARB names a lift-mechanism pin that never arrives where it should as a failure the OBD system must find, which is what this feedback check exists for. Sticking pins and deposits are therefore the main suspects. Bank 1 counterpart: P2B48.
Possible causes
- Exhaust actuator pin sticking (deposits, wear) high
- Engine control software outdated medium
- Intermittent contact in the sensor signal low
Symptoms
- Check engine light on
- Lift system or cylinder deactivation in limp-home
- Higher part-load consumption
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2B4C
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.