OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B4A

B Camshaft Position Actuator Position Sensor B Circuit High Bank 1

P2B4A says the position sensor B signal of the bank 1 exhaust camshaft actuator is above its limit. An interrupted sensor ground, a short to a voltage source or a failed sensor are typical. No manufacturer describes P2B4A publicly, and the Mercedes CAMTRONIC bulletin does not include any high fault of this family. As a comparison only, GM checks the exhaust sliding-cam circuits of the 2.7-litre L3B for an unwanted link to supply voltage with the output switched off (P2C15, 0.5 Ω, 4 of 5 samples, Type A). The engine module keeps the exhaust lift system in its safe position until the fault is gone. CARB counts such sensors among the comprehensive components that need circuit monitoring. Exhaust low fault on bank 1: P2B49.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 4A

Possible causes

  • Sensor ground interrupted or connector corroded high
  • Signal line shorted to a voltage source medium
  • Sensor failed medium

Symptoms

  • Check engine light on
  • Exhaust lift system kept in safe position
  • Usually unchanged driveability

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2B4A

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication