P2B48
B Camshaft Position Actuator Position Sensor B Range/Performance Bank 1
P2B48 is the plausibility code for sensor B at the bank 1 exhaust actuator (camshaft B): the circuit works, yet the reported position contradicts the command. Mercedes handles this fault type on its CAMTRONIC V8s for the exhaust sensor of solenoid 1 as P34BD and fixes it through software and newer actuators; P2B48 itself is not found in any public manufacturer source. GM's L3B gives an idea of the logic under P2C13: the exhaust Hall feedback must pass through three states per shift, and a signal without a shift command also counts as an error. Carbon or sludge on the actuator pin, worn parts or a damaged shift groove can cause the mismatch. Bank 2 counterpart: P2B4C.
Possible causes
- Actuator pin sticking from deposits or wear high
- Outdated engine control software medium
- Shift groove or cam sleeve damaged low
Symptoms
- Check engine light on
- Exhaust lift switching held in one position
- Possibly rough running during shift attempts
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2B48
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.