P2B44
A Camshaft Position Actuator Position Sensor B Range/Performance Bank 2
P2B44 is the one code of this group with a public manufacturer use. Mercedes-Benz bulletin LI05.20-P-080192 (January 2026) lists P2B4400 on M176/M177 V8 engines – AMG 63 models, S 580, G 550, GLS 580 – and reads it as an implausible sensor signal from CAMTRONIC solenoid 2 on the intake side of bank 2. The bulletin blames software and hardware: update the engine control unit, fit the newest actuator part numbers and inspect the harness near the windshield for heat damage. Related codes in the same bulletin show the system then going into limp-home mode (P164B). In short, the signal is electrically present but disagrees with the pin movement that was commanded. Bank 1 counterpart: P2B40.
Possible causes
- Engine control software needs the CAMTRONIC update (Mercedes) high
- Actuator of an older part number (Mercedes replaces it) high
- Harness heat-damaged near the windshield medium
Symptoms
- Check engine light on
- CAMTRONIC limp-home mode, cylinder deactivation off
- Higher fuel consumption at part load
Inspection / repair
- Difficulty: shop only
- DIY: shop recommended
What Pro shows you for P2B44
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.