P2B43
A Camshaft Position Actuator Position Sensor B Circuit Bank 2
P2B43 covers the wiring of sensor B at the bank 2 intake actuator, i.e. on the cylinder bank without cylinder 1, so it only appears on V or boxer engines. The engine module sees an open line or a signal it cannot accept at all. On Mercedes V8s with CAMTRONIC (M176/M177) the intake actuator of bank 2 is exactly where bulletin LI05.20-P-080192 places the sister fault P2B44; the same bulletin asks technicians to check the harness above the bulkhead for heat damage, which fits a circuit code as well. P2B43 itself is not described in any public manufacturer document. CARB demands that every sensor of a variable valve system is monitored for circuit faults. Bank 1 counterpart: P2B3F.
Possible causes
- Harness near the bulkhead damaged by heat high
- Actuator connector loose or corroded medium
- Sensor in the actuator failed medium
Symptoms
- Check engine light on
- Cylinder deactivation or lift change switched off
- Possibly limp-home message of the valve-lift system
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B43
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.