OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B42

A Camshaft Position Actuator Position Sensor B Circuit High Bank 1

Here sensor B of the bank 1 intake actuator reports a value stuck above its upper limit. Typical reasons are an open sensor ground, a signal line touching 5 V or battery voltage, or a defective sensor. No manufacturer explains P2B42 publicly; the supplier list from NTN-SNR only names it as the inlet-side sensor B with a signal that is too high. GM measures the related sliding-cam circuits of its L3B (P2C08) for contact with supply voltage while the output is switched off, again at 0.5 Ω and 4 of 5 samples, and lights the MIL on the first trip – a comparison, not a statement about this code. On Mercedes CAMTRONIC engines the sensor sits in the actuator, so a failed sensor means replacing the actuator. Low is P2B41.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 42

Possible causes

  • Sensor ground open or connector corroded high
  • Signal wire shorted to 5 V or battery voltage medium
  • Sensor (actuator) faulty medium

Symptoms

  • Check engine light on
  • Intake lift change locked out
  • Usually no noticeable change in driving, sometimes reduced power

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2B42

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication