P2B40
A Camshaft Position Actuator Position Sensor B Range/Performance Bank 1
With P2B40 the wiring of the intake-side sensor B (camshaft A, bank 1) is electrically fine, but its signal does not fit what the engine module commanded. Engines with switchable cam lift use such feedback to confirm that a pin really moved; GM's L3B, as a comparable case under P2C06, logs a fault when the Hall feedback shows movement although no shift was requested, or when the extending, extended and retracted states do not appear. Mercedes documents the same fault type for bank 2 as P2B44 (CAMTRONIC, M176/M177) and cures it with new software and revised actuators. For P2B40 itself there is no public manufacturer text. A sticking or worn actuator is more likely here than a wiring fault.
Possible causes
- Actuator pin sluggish or sticking (wear, oil sludge) high
- Engine control software outdated (Mercedes CAMTRONIC update) medium
- Sensor signal disturbed by loose contact medium
- Cam sleeve or shift groove damaged low
Symptoms
- Check engine light on
- Valve-lift change held in a safe position
- Uneven running when the system tries to switch
Inspection / repair
- Difficulty: hard
- DIY: shop recommended
What Pro shows you for P2B40
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 4 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.