OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B3F

A Camshaft Position Actuator Position Sensor B Circuit Bank 1

P2B3F is the general circuit code for position sensor B of the intake camshaft actuator (camshaft A) on bank 1, the side with cylinder 1; the NTN-SNR sensor guide also places it on the inlet side. Mercedes-Benz uses this code family on its M176/M177 V8 engines, where each CAMTRONIC lift actuator reports its own sensor signal and sensor B belongs to solenoid 2. No manufacturer documents P2B3F itself publicly. For comparison, GM's 2.7-litre L3B judges the feedback circuits of its sliding-cam actuators (P2C05 ff) as open once it sees 200 kΩ or more between signal and ground in 4 of 5 samples, Type A. Expect a broken wire, a loose plug or a failed sensor; the engine control then locks out the lift change. Low and High faults have their own codes, P2B41 and P2B42.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 3F

Possible causes

  • Connector at the actuator loose, corroded or wire broken high
  • Position sensor in the actuator failed (actuator replacement) medium
  • Engine harness damaged by heat or chafing medium
  • Engine control module fault low

Symptoms

  • Check engine light on
  • Lift switching or cylinder deactivation unavailable
  • Slightly higher consumption, sometimes less power

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B3F

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication