P2B39
B Camshaft Profile Actuator B Control Circuit/Open Bank 1
Camshaft B is the exhaust camshaft, and actuator B is the second shifting solenoid on it. On GM's 2.7-litre L3B the exhaust side has only two such actuators, so this is the last of them; GM's tables call it exhaust camshaft profile actuator 2. P2B39 flags an open control circuit: with the output commanded on, the ECM reads an impedance of at least 200 kΩ to ground. It needs 4 failures in 5 samples, a supply above 11 V and key in crank or run, and it turns the MIL on in the first trip. A loose connector on the camshaft carrier, a broken wire or an open coil are the usual causes. The exhaust sleeve then stays put, so the engine cannot change profile on that side. The intake counterpart is P2B33.
Possible causes
- Exhaust actuator connector loose or corroded on the camshaft carrier high
- Broken wire in the engine harness medium
- Open solenoid coil in exhaust actuator B medium
Symptoms
- MIL on in the first drive
- Exhaust lift profile no longer switches, cylinder deactivation unavailable
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B39
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.