OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B33

A Camshaft Profile Actuator B Control Circuit/Open Bank 1

P2B33 concerns the second profile actuator on the intake camshaft (camshaft A) of bank 1. Such actuators are solenoids that extend a pin into a groove on a sliding cam sleeve and so move lobes of a different lift under the valves. GM uses the code on the 2.7-litre turbo four L3B (Silverado and Sierra 1500 from 2019), whose sliding cam system has four intake and two exhaust actuators; GM calls this one actuator 2. The ECM energises the output and flags an open circuit when it sees 200 kΩ or more between signal and ground in 4 of 5 samples, with supply above 11 V; MIL on the first trip (Type A). With the sleeve unable to move, lift switching and cylinder deactivation stay locked out. Low and High are P2B34 and P2B35.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 33

Possible causes

  • Connector at the actuator on the camshaft carrier loose, corroded or not latched after valve cover work high
  • Solenoid winding of actuator B open medium
  • Control wire broken in the engine harness medium
  • Output stage in the engine control module faulty low

Symptoms

  • MIL on after the first drive with the fault
  • No change of intake lift profile, less pull or higher fuel use depending on the stuck profile
  • Cylinder deactivation no longer engages

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B33

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication