OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B26

Hybrid/EV Electronics Coolant Temperature Sensor C Circuit Low

The voltage on the signal line of sensor C, the third coolant sensor in the power electronics loop, is lower than the controller accepts. Low means voltage here, not temperature: on an NTC sensor it corresponds to an implausibly hot value. A pinched or chafed lead touching the body, a short inside the sensor or coolant that has crept into the plug are the usual findings. No manufacturer documents P2B26 publicly; the NTN-SNR catalogue describes a signal of sensor C that is too small. CARB requires inverter cooling inputs to be checked for values outside their range; for sensor A, GM uses 4 % of the reference (0.2 V) as the lower limit. Since the reading suggests overheating, controllers tend to run pump and fans hard and may reduce power. The open or high case is P2B27, a plausible but wrong value P2B25.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 26

Possible causes

  • Sensor C signal lead pinched or chafed against ground high
  • Coolant wicking into the sensor plug medium
  • Shorted sensor C element medium

Symptoms

  • Warning lamp or system message
  • Pump and radiator fan running hard even when cool
  • Reduced power in some situations

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B26

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication