P2B21
Hybrid/EV Electronics Coolant Temperature Sensor B Circuit Range/Performance
Here sensor B delivers a voltage inside its electrical window, yet the temperature it reports does not fit the rest of the vehicle: it may stay flat while the electronics warm up, or disagree with other temperatures after the car has stood for hours. No manufacturer publishes the set condition of P2B21. NTN-SNR names it a deviation or malfunction of the sensor B signal. For sensor A, GM's 2019 HPC2 table runs such a test once per key cycle after a long rest and checks the reading against outside air, transmission fluid and the refrigerant high side (limits 27–28 °C, 8 s in 10 s, Type B as P0CEF). Typical causes are a drifting element, trapped air at the sensor tip or corroded contacts. Hard electrical faults go to P2B22 and P2B23, the A/B comparison to P2D2A.
Possible causes
- Sensor B element drifted out of its characteristic curve high
- Air pocket around the sensor after coolant service or a leak medium
- Corroded or loose terminals adding resistance to the signal medium
- Controller calibration that needs an update low
Symptoms
- Hybrid system warning, often only after a cold start
- Cooling pump or fan behaviour that does not match conditions
- Occasionally limited electric power
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B21
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.