P2B1D
Cylinder 7 Injection Pulse Offset Exceeded Learning Limit
P2B1D reports that the correction learned for injector 7 during Ford's zero-fuel calibration has gone beyond its limit; cylinder 7 exists only on the 6.7 L V8. Ford's TSB 25-2412 for 2023–2025 F-Super Duty trucks calls the warning lamp in many such cases incorrect: learned values skewed by operation above 762 m, sometimes with a slightly uneven idle. The repair is a calibration update for PCM and TCM, followed by resetting the minimum fuel mass adaptions. Ford's 2023 summary also shows the neighbouring fuel balancing control, which reports P0281 for cylinder 7 once more than 90 % of its permitted correction is used; both learns act on the same injector, so a balance code next to P2B1D points more towards real injector wear than towards a software issue.
Possible causes
- Calibration learning wrong values at altitude (Ford TSB 25-2412) high
- Injector 7 worn, often with balance code P0281 as well medium
- Interference on the crank or cam speed signal low
Symptoms
- Check engine light, sometimes without a real fault
- Slightly uneven idle
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B1D
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.