OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B1C

Cylinder 7 Injection Pulse Offset Not Learned

P2B1C says no learned offset exists for injector 7, which only applies to engines with at least seven cylinders, in practice V8s. No manufacturer publishes a monitor for this code. A GM patent on small-quantity adaption shows that a learn can also fail to finish because results do not settle: several test injections during fuel cut-off are compared, and an injector whose consecutive values scatter too much gets a low confidence rating and is marked suspicious instead of passing. A noisy speed signal, an injector with erratic opening or a leak in the high-pressure system can therefore block a valid value. Bosch's zero-fuel calibration patent rests on the same speed-based detection. CARB (f)(4.2.4)(A)(i) asks for missing learning to be flagged; P2B1D is the out-of-range sibling.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 1C

Possible causes

  • Test results for injector 7 scattering too much to be accepted medium
  • Learn restarted after injector or control unit replacement medium
  • Leak in the high-pressure system disturbing the test injection low

Symptoms

  • Warning lamp
  • With an erratic injector, uneven idle or knocking on one cylinder

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B1C

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication