OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B1B

Cylinder 6 Injection Pulse Offset Exceeded Learning Limit

P2B1B concerns injector 6. On Ford's 3.0 L V6 Power Stroke it is the last cylinder the zero-fuel monitor checks, on the 6.7 L V8 the sixth of eight. The code means the energising time at which injector 6 starts to deliver has moved too far from its stored target, beyond the learn limit. Ford TSB 25-2262 superseded TSB 23-2076 with newer PCM software: driving above 762 m could leave wrong learned values, the engine might idle slightly rough, and Ford states that driveability and durability are not affected. The procedure is reprogramming PCM and TCM and then resetting the minimum fuel mass adaptions. Mechanical causes remain possible, so a code that persists after reflash and reset calls for a contribution check (P0278) and a test of injector 6.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 1B

Possible causes

  • PCM software learning wrong values at altitude (Ford TSB 25-2262) high
  • Injector 6 drifted by wear or deposits medium
  • Adaptions not reset after an earlier repair low

Symptoms

  • Malfunction indicator lamp on
  • Slightly rough idle, driveability otherwise normal

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B1B

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication