P2B18
Cylinder 5 Injection Pulse Offset Not Learned
P2B18 means injector 5 has no learned offset. No manufacturer documents this exact code. On petrol direct injection GM covers a related idea with codes of its own: in the 2025 V8 table the ECM adds up the opening magnitude and closing time compensation of each injector, both derived from the feedback voltage, and P10AB or P10AC set for cylinder 5 when that sum is below the minimum or above the maximum limit (Type B, 50 to 100 samples). A not-learned status, by contrast, says that no usable value exists yet, for example after a new injector or control unit or after an adaption reset. For diesel engines CARB (f)(4.2.4)(A)(i) requires detection of feedback that does not start in time. The limit-exceeded twin is P2B19.
Possible causes
- New injector 5 or control unit without a completed learn high
- Enabling conditions for the learn not met often enough medium
- Faulty injector 5 wiring preventing a valid measurement low
Symptoms
- Warning lamp
- Rarely noticeable; at most slightly uneven low-load running
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B18
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.