OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B17

Cylinder 4 Injection Pulse Offset Exceeded Learning Limit

P2B17 is set when injector 4's learned pulse offset goes past the allowed band. For the 6.7 L engine in 2020–2022 F-Super Duty trucks Ford saw this after fuel system work: stored learned values no longer matched the new parts. Special service messages 50646 and 50816 prescribe a relearn rather than a module swap – idle for at least six minutes with coolant at 75 °C or more and exhaust temperature EGT12 at 245 °C (pickups) or EGT13 at 230 °C (chassis cabs), then clear the code and retest; a new PCM is not needed. If P2B17 returns after that, a worn or leaking injector 4, a contribution fault (P0272) or a rail pressure problem remain the candidates. Ford's summary sets the code when the measured energising time misses the target by 156 µs downward or 254 µs upward.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 17

Possible causes

  • Old learn values after fuel system work, cleared by a warm idle relearn (Ford SSM 50646/50816) high
  • Injector 4 worn or leaking internally medium
  • Rail pressure deviating from target during the test injection low

Symptoms

  • Check engine light shortly after a fuel system repair
  • Usually unchanged driving behaviour

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B17

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication