P2B14
Cylinder 3 Injection Pulse Offset Not Learned
P2B14 tells that no offset has yet been learned for injector 3. No carmaker publishes this code for a specific engine, and the GM and Ford tables checked do not contain it. A GM patent on fast learning of diesel injector corrections shows why such a learn can take long: corrections are kept per injector and per rail pressure level, so a six-cylinder with four pressure levels needs 24 learned cells, each filled only during suitable fuel cut-off phases. The patent's answer is to extrapolate from one measured pressure to the others. Until the cells for cylinder 3 are complete, small pilot injections on that cylinder run without their individual correction. Under CARB (f)(4.2.4)(A)(i) such feedback must start within a set time; P2B15 is the out-of-limit partner.
Possible causes
- Learn not yet completed for all rail pressure levels of injector 3 high
- Injector 3 or control unit recently replaced without completing the learn medium
- Rail pressure not holding steady enough during the test injection low
Symptoms
- Warning lamp, driving behaviour mostly unchanged
- Slightly uneven idle in some cases
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B14
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 2 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.