OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B12

Cylinder 2 Injection Pulse Offset Not Learned

P2B12 is stored when injector 2's pulse offset has not been learned, so the controller still relies on a default value for the smallest injections. The public record contains no manufacturer using this exact code; the explanation here follows from the title and from the neighbouring monitors. Learning of this kind needs repeated coasting phases with fuel cut-off, because only then can the effect of a single test injection be picked up through the crankshaft speed signal, as a Bosch patent on zero-fuel quantity calibration sets out. Engines that rarely coast – long motorway runs, towing – or a recent adaption reset after injector work can therefore leave the learn unfinished. CARB treats feedback that never starts in time as a fault. Once learned but too far off, cylinder 2 reports P2B13 instead.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 12

Possible causes

  • Driving profile without enough fuel cut-off phases (constant load, towing) high
  • Adaption values reset after work on injector 2 or the fuel system medium
  • Crankshaft speed signal too noisy to detect the test injection low

Symptoms

  • Warning lamp without a clear driveability complaint
  • Possibly louder combustion on cylinder 2 at low load

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B12

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication