OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B11

Cylinder 1 Injection Pulse Offset Exceeded Learning Limit

P2B11 says the learned small-quantity correction for injector 1 has drifted beyond what the engine control may apply. Ford documents the code for its 3.0 L and 6.7 L Power Stroke diesels under Zero Fuel Calibration: the PCM fires a tiny test injection, compares the energising time that produced a measurable effect with the target stored for that injector and sets the code when the result is at least 156 µs too short or 254 µs too long. Ford TSB 18-2015 for the 2017 F-Super Duty 6.7 L ties P2B11 and its siblings to a fuel knock at idle caused by wrongly learned injector timing; the fix was resetting the high-pressure side, the minimum fuel mass adaption and the crank sensor learn, then reprogramming the PCM. P2B10 is the not-learned state of the same injector.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 11

Possible causes

  • Incorrectly learned injector values in the PCM (Ford TSB 18-2015, reset and reprogramming) high
  • Injector 1 worn or coked so its opening behaviour has really shifted medium
  • Disturbed crankshaft speed signal falsifying the learn result low

Symptoms

  • Check engine light
  • Diesel knock at idle, sometimes together with balance code P0263

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B11

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication