OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B10

Cylinder 1 Injection Pulse Offset Not Learned

P2B10 means the engine control holds no valid learned offset for injector 1 – the correction of the opening time used for very small injection quantities has not been established. No manufacturer documents this code publicly. Ford, the one maker with a published monitor for this group, lists only the exceeded-limit codes (P2B11 and siblings) for its Power Stroke diesels. The legal basis is CARB 13 CCR 1968.2 (f)(4.2.4)(A)(i): a fuel system feedback that does not begin working within a time chosen by the manufacturer counts as a malfunction. A Bosch patent explains the learn itself: in overrun the activation time of a test injection is raised in small steps from a value too short to open the injector until the crankshaft speed reacts. P2B11 is the partner for a value that was learned but lies out of range.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 10

Possible causes

  • Learn values cleared – after replacing injector 1 or the control unit, or after an adaption reset with a scan tool high
  • Too few coasting phases with fuel cut-off for the learn to run medium
  • Injector 1 opening inconsistently, so no stable value is found low

Symptoms

  • Warning lamp, otherwise often no noticeable effect
  • Possibly harder combustion noise at idle on cylinder 1

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B10

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 2 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication