P2B0F
Cold Start Cylinder 8 Injection Pulse Performance
P2B0F closes the cold-start series with cylinder 8, so it only appears on eight-cylinder engines; publicly GM documents it, in table 25OBDG06A for its 2025 V8 family (Type B, two trips, 50 to 100 samples). The ECM reads the voltage across the injector enable and command wires and treats a pulse as undelivered when no opening magnitude shows up during catalyst heating. The same table watches cylinder 8 in other ways too: the warm-running pulse check P2B07 and GM's own codes P10B1 and P10B2, which set when the total small-pulse compensation of that injector falls below or rises above its limit. One enabling condition is that the enrichment for brand-new engines is no longer active. No service bulletin naming P2B0F was found.
Possible causes
- Needle or armature of the cylinder 8 injector sticking on cold short pulses medium
- Loose or corroded connector at injector 8 medium
- Chafed injector harness on the bank carrying cylinder 8 low
Symptoms
- Check engine light, frequently without driveability complaints
- With a real injector fault, rough cold idle and possibly misfire on cylinder 8 (P0308)
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B0F
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.