OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B0E

Cold Start Cylinder 7 Injection Pulse Performance

P2B0E is the cylinder 7 entry of the cold-start pulse check. On engines that fire two or three short injections per cycle while heating the catalyst, the ECM expects each of them to show an opening signature on the injector feedback voltage; for cylinder 7 too many did not. GM's 2025 V8 supporting tables (25OBDG06B) show how the pulse count is chosen: double pulses are permitted up to 3,600 rpm and triple pulses up to 3,000 rpm, depending on the injector energy profile. The summary code P2B95 adds up the share of missed pulses over all cylinders once per trip, whereas P2B0E names the single cylinder (Type B, 50 to 100 samples, table 25OBDG06A). CARB phases this split-pulse check in over model years 2026 to 2028. The warm-running counterpart is P2B06.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 0E

Possible causes

  • Cylinder 7 injector not lifting on the very short split pulses (deposits, armature wear) medium
  • Enable or command wire of injector 7 damaged, falsifying the measured voltage medium
  • ECM software with an overly strict opening-signature evaluation low

Symptoms

  • Warning lamp after the second faulty cold start
  • Slight shaking right after a cold start, often nothing noticeable

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B0E

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication