OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B0D

Cold Start Cylinder 6 Injection Pulse Performance

P2B0D belongs to the cold-start family and points at cylinder 6: while the engine was splitting injections to heat the catalyst, the ECM failed to register the armature-lift voltage signature on too many of that injector's pulses. GM publishes it in the 2025 V8 table 25OBDG06A as Type B with a verdict after 50 to 100 samples. What keeps the test short is its exit list: the cold-start strategy ends once the catalyst reaches 800 °C, barometric pressure drops below 72 kPa or an extended run-time limit expires, and multi-pulse mode stops above 2,350 rpm, beyond 3 % pedal or after 100 s. No bulletin naming P2B0D was found. Warm-engine misses on cylinder 6 are P2B05; misfire on that cylinder is P0306.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 0D

Possible causes

  • Cylinder 6 injector opening sluggishly on short pulses when cold (deposits, worn armature) medium
  • Corroded connector or chafed wire at injector 6 distorting the feedback voltage medium
  • ECM calibration detecting the opening signature unreliably in the cold-start phase low

Symptoms

  • Check engine light after two cold starts with the fault
  • Uneven idle in the first minute after a cold start, later normal

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B0D

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication