OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B08

Cold Start Cylinder 1 Injection Pulse Performance

P2B08 is the cold-start version of the cylinder 1 pulse check. While the catalyst is being heated, many direct-injection engines split each injection into two or three small pulses, and CARB requires for 20/50/100 % of model years 2026/2027/2028 that missing split or multiple pulses be detected during the cold-start strategy. CARB also wants faults found in that phase stored under their own codes, which is why P2B08 exists beside P2B00. GM used it earlier: its tables flag cylinder 1 when the opening signature is missing during catalyst warm-up, Type B. For the 1.2 L LIH in the 2020 Encore GX and 2021 Trailblazer, GM bulletin PIP5746 calls it a software anomaly appearing only on cold starts; verify after an overnight soak.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 08

Possible causes

  • Cold-start software anomaly (GM 1.2 L LIH, fixed by ECM reprogramming) high
  • Cylinder 1 injector sluggish when cold, missing the short split pulses medium
  • Contact fault in injector 1 wiring that shows mainly when cold low

Symptoms

  • Warning lamp, often with the engine running normally once warm
  • Possibly slightly rough running in the first seconds after a cold start
  • Code returns only after a long standstill, not on warm restarts

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B08

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication