P2B07
Cylinder 8 Injection Pulse Performance
P2B07 closes the warm-running row at cylinder 8, and the engine-wide check counting missed pulses over all cylinders is P2B96. No manufacturer documents P2B07 publicly as a separate monitor; GM's 2025 V8 tables mention it only in the code lists of shared calibration tables, while their cylinder 8 warm faults run as P10B1/P10B2. If a scan tool still shows P2B07, the logic matches the GM principle: injector coil voltage is sampled, and a missing opening trace means the pulse was not delivered. On many V8 designs cylinder 8 sits at the rear of a bank, close to the bulkhead and hot exhaust parts, so look at harness heat damage as well as the injector itself. Cold start: P2B0F.
Possible causes
- Cylinder 8 injector not opening properly high
- Heat-damaged harness section at the rear of the engine medium
- Loose or corroded injector 8 connector low
Symptoms
- Check engine light
- Misfire on cylinder 8 (P0308), especially at idle
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2B07
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.