OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2B00

Cylinder 1 Injection Pulse Performance

P2B00 says the engine module could not confirm, with the engine past its cold-start phase, that injection pulses it commanded for cylinder 1 really happened. GM documents the check for its petrol direct-injection engines: the ECM digitises the voltage across both injector wires and looks for the small flux signature the armature leaves when it lifts. If that opening trace is missing too often – 100 failures in 200 samples in the 2018 four-cylinder table, Type B, lamp after two trips – the pulse counts as lost. GM only runs it with at least 5 MPa rail pressure, 5 s engine run time and 10 % fuel in the tank. GM bulletins name P2B00 on the 2.7 L L3B (chafed engine harness) and the 1.2 L LIH (ECM software). The cold-start twin for cylinder 1 is P2B08.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberB / 00

Possible causes

  • Engine harness chafed through to ground (GM L3B – above the camshaft carrier or near the left shock tower) high
  • Armature or needle of the cylinder 1 injector sticking, so no opening signature appears medium
  • Outdated ECM calibration (GM service update for the 1.2 L LIH) medium
  • High contact resistance at the cylinder 1 injector connector low

Symptoms

  • Check engine light after the second faulty trip
  • Rough running or misfire on cylinder 1 (P0301), sometimes no noticeable symptom
  • With a harness short, several unrelated codes at once and possibly a no-start

Inspection / repair

  • Difficulty: medium
  • DIY: shop recommended

What Pro shows you for P2B00

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication