P2AFB
Starter Relay D Stuck Off
P2AFB is set when starter relay D ignores an on command: the module energises it, but the expected change of voltage or current in the switched circuit never appears. No manufacturer documents P2AFB publicly. Stellantis shows on relay C how such a check works. Its Starter Relay 3 Stuck Off (P2AF6) is stored when both battery voltages stay equal during an auto-start although the relay should have separated them, and the published remedies range from a loose connector at the power distribution centre to new PCM software. For relay D, burnt or corroded contacts, a weak coil, low supply voltage and a poor ground are the usual suspects. Drivers may see a no-crank or an auto-stop that stays unavailable. The stuck-on counterpart is P2AFA; circuit faults are P2AF7 to P2AF9.
Possible causes
- Burnt or corroded relay contacts high
- Low supply voltage or poor ground at the relay medium
- Loose connector at the relay or distribution box medium
Symptoms
- Engine does not crank on the affected path
- Auto-stop permanently unavailable
- Stored code, lamp depending on manufacturer
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2AFB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.