P2AFA
Starter Relay D Stuck On
P2AFA describes starter relay D staying engaged although the control module has commanded it to release; the module infers this from a feedback signal, a voltage or current that should have changed. No manufacturer documents P2AFA publicly. The closest published case is relay C at Stellantis, where Starter Relay 3 Stuck On (P2AF5) is detected from the voltage gap between main and auxiliary battery. A relay welded closed in a cranking path can keep the starter spinning after the engine fires, which risks damage to starter and ring gear, whereas a stuck battery isolation relay mainly blocks stop-start and the charging of the second battery. Causes are welded contacts, a live control wire (see P2AF9) or a faulty driver. The opposite stuck fault is P2AFB.
Possible causes
- Welded relay contacts high
- Control wire receiving voltage from another circuit medium
- Output driver not switching off low
Symptoms
- Starter keeps turning or grinding after the engine starts
- Stop-start disabled
- Battery drain while parked
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2AFA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.