P2AF7
Starter Relay D Control Circuit/Open
P2AF7 is the open-circuit or general fault on the control line of a fourth starter relay, relay D. Four separately monitored starter relays only make sense where there is more than one cranking path, for example a pinion relay, a second starter or a battery isolation stage on a stop-start engine. No manufacturer documents P2AF7 publicly, and the Stellantis bulletins that use relay C do not name a relay D. CARB requires engine computers to monitor output components for lost continuity. As a comparison, GM considers its relay A and B outputs open once the circuit looks like 200 kΩ or more toward ground, after 40 failures in 50 samples. Typical causes are a broken wire, a corroded plug, an open coil or a blown supply fuse. P2AF8 and P2AF9 separate the grounded and the live control wire.
Possible causes
- Broken control wire or corroded connector high
- Open coil in relay D medium
- Blown fuse feeding the relay coil medium
Symptoms
- Auto-stop not available
- Intermittent no-crank
- Stored code, lamp depending on manufacturer
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2AF7
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.