P2AF4
Starter Relay C Control Circuit High
P2AF4 points to a control wire of starter relay C that carries battery voltage when the module has switched its driver off, typically because it touches a 12 V feed or because the driver leaks. With supply-side switching that can keep the coil energised; with ground-side switching the module can no longer pull the relay in. No manufacturer publishes P2AF4. Relay C is known as Starter Relay 3 at Stellantis, the relay that isolates the auxiliary battery during stop-start restarts, but its published cases concern the stuck codes P2AF5 and P2AF6 only. As a reference, GM checks the tandem starter pinion relay (P26E6) with the driver off for a short toward supply, at 0.5 Ω or less to supply, 40 failures in 50 samples, Type B over two trips. Ground and open faults are P2AF3 and P2AF2.
Possible causes
- Control wire shorted to a 12 V circuit high
- Leaking or failed output driver medium
- Water in the relay socket or power distribution box low
Symptoms
- Stop-start disabled
- Relay may stay engaged with ignition off
- Warning lamp depending on manufacturer
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2AF4
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.