OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AF3

Starter Relay C Control Circuit Low

P2AF3 sets when the control line of starter relay C is pulled toward ground at a moment the module expects a different level. What that does to the relay depends on the driver type: with ground-side switching the short acts like a permanent on command, with supply-side switching the coil never gets current. No manufacturer publishes a set condition for P2AF3. Stellantis uses relay C as Starter Relay 3, the battery isolation relay of its stop-start Jeep and RAM models, where an energised coil splits the two batteries; only the stuck codes of that relay appear in its bulletins. GM's comparable short-to-ground test on the tandem starter pinion relay (P26E5) looks for 0.5 Ω or less to ground with 8 failures in 10 samples, Type B. Open and short-to-voltage faults are P2AF2 and P2AF4.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / F3

Possible causes

  • Control wire chafed through to ground high
  • Shorted relay coil medium
  • Faulty output driver in the control module low

Symptoms

  • Stop-start inoperative
  • Relay energised all the time or not at all, depending on circuit design
  • Possible no-crank

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2AF3

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication