P2AF0
Intake Air O2 Sensor Negative Current Control Circuit Low Bank 2
P2AF0 is stored when the negative current control circuit of the bank 2 intake oxygen sensor falls below its window. Because the return is meant to sit at a bias of roughly 2.5 V, which Saab's 2010 9-5 lists as the test value on terminal 2 of its exhaust probe, any path to chassis ground pulls it down: insulation worn through at a clip, a crushed connector or an internal short in the sensor. Ford assigns a grounded VM lead on bank 2 exhaust probes to P0151. No manufacturer publishes P2AF0, so the description rests on CARB's range checks and the Bosch pinout. When bank 1 shows P2AE7 as well, suspect a shared harness section first. With the bias gone, the oxygen value of bank 2 is unusable and EGR is cut back. P2AEF is open, P2AF1 high, P2AED the low fault on the pump lead.
Possible causes
- Return lead worn through at a clip or bracket high
- Crushed or damaged sensor connector medium
- Internal short of the sensor to ground low
Symptoms
- Check engine light on
- EGR on bank 2 cut back, possibly higher NOx
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2AF0
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p2237-p2239-p2243-p2251-or-p2626
- newtonnet.co.uk/fiesta/fordobd2012.pdf
- bosch-motorsport.com/content/downloads/Raceparts/Resources/pdf/Data Sheet_69034379_Lambda_Sensor_LSU_4.9.pdf
- law.cornell.edu/regulations/california/13-CCR-1968.2