P2AEE
Intake Air O2 Sensor Pumping Current Circuit High Bank 2
P2AEE marks the pumping current lead of the bank 2 intake air oxygen sensor as too high. Contact with the heater feed in the shared plug, chafing against a live wire or water that has entered the connector can raise it. On exhaust probes of bank 2, Ford records a battery short of the IP wire as P0152, and CARB obliges the ECM to detect such out-of-range inputs; a code-specific description of P2AEE for the intake side has not been published by any manufacturer. Ford's patent US9441564B2 adds a quirk typical of this sensor: hydrocarbons from crankcase ventilation burn off oxygen at the hot element and distort the reading, but that is a plausibility issue, not an electrical one. Measure the lead against battery voltage before renewing the sensor. P2AED is low, P2AEC open, P2AE5 bank 1.
Possible causes
- Pump current lead touching the heater feed high
- Harness chafed against a live wire medium
- Water inside the sensor connector low
Symptoms
- Check engine light on
- EGR on bank 2 reduced, NOx may rise
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2AEE
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.