P2AEB
Intake Air O2 Sensor Pumping Current Trim Circuit High Bank 2
P2AEB indicates excessive voltage on the trim wire serving the second bank's intake O2 sensor. A short to the heater or another supply wire, or moisture bridging contacts in the plug, can lift the line; Saab's 2010 9-5 test procedure for the comparable exhaust probe expects roughly 2.8 V on its trim terminal at ignition-on, so a reading near battery voltage is a clear sign. Ford's exhaust analog for bank 2 is P2631, used only on NTK probes for a trim lead shorted to battery. For an intake sensor on bank 2 no manufacturer documentation exists; CARB's comprehensive-component rule is the basis. Since the resistor sets the characteristic, a falsified trim value shifts the oxygen reading and with it the EGR calculation of that bank. P2AEA is low, P2AE9 open, P2AE2 bank 1.
Possible causes
- Trim lead shorted to the heater or another supply high
- Moisture bridging contacts in the plug medium
- Internal short in the sensor connector module low
Symptoms
- Check engine light on
- EGR on bank 2 reduced, NOx may rise
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2AEB
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p2237-p2239-p2243-p2251-or-p2626
- newtonnet.co.uk/fiesta/fordobd2012.pdf
- bosch-motorsport.com/content/downloads/Raceparts/Resources/pdf/Data Sheet_69034379_Lambda_Sensor_LSU_4.9.pdf
- law.cornell.edu/regulations/california/13-CCR-1968.2