P2AEA
Intake Air O2 Sensor Pumping Current Trim Circuit Low Bank 2
P2AEA reports a trim circuit voltage below the permitted range at the bank 2 intake O2 sensor. Likely culprits are a trim wire grounded where the harness passes the second turbocharger, or a damaged resistor inside the sensor connector. Ford's 2012 summary assigns the exhaust analog P2630 to NTK probes for an open or grounded RL lead, a reminder that a low reading need not mean a short. Engines with a separate bank 2 intake sensor are rare and no manufacturer documents P2AEA. If P2AE1 is stored too, look at what both sensors share, such as a ground point or the ECM; alone, P2AEA points to the bank 2 sensor and its own wiring. Meanwhile the EGR on that bank loses its oxygen feedback; the lamp comes on and NOx can rise, but the car usually drives normally. P2AE9 is the open, P2AEB the high fault.
Possible causes
- Trim lead grounded near the second turbocharger high
- Calibration resistor in the plug damaged medium
- Fault in a ground or ECM path shared with bank 1 low
Symptoms
- Check engine light on
- Higher NOx, driveability usually unchanged
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2AEA
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.