OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AE9

Intake Air O2 Sensor Pumping Current Trim Circuit Open Bank 2

P2AE9 is the bank 2 version of the open trim circuit: the line from the ECM to the calibration resistor of the second intake air oxygen sensor has no continuity. A separate sensor for bank 2 only makes sense where each cylinder bank draws its charge or EGR through its own path; nobody has published a vehicle that uses P2AE9. The logic follows the exhaust analog P2629, which Ford sets for Bosch probes when the pumping current in air remains too high during a fuel cut-off event; Saab rates the bank 1 twin P2626 as Type B. As the Bosch datasheet explains, the resistor in the plug fixes the sensor's characteristic curve, so a broken trim lead leaves the reading of that bank uncalibrated. A pin pushed back in the connector is a frequent finding. P2AEA/P2AEB are low/high, P2AE0 bank 1.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / E9

Possible causes

  • Trim contact pushed back in the plug high
  • Trim lead broken, often near the hot exhaust of bank 2 medium
  • Calibration resistor in the sensor connector open low

Symptoms

  • Check engine light on
  • EGR on bank 2 reduced or without feedback

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2AE9

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication