OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AE7

Intake Air O2 Sensor Negative Current Control Circuit Low Bank 1

P2AE7 is set when the virtual-ground return of the bank 1 intake oxygen sensor is pulled below its bias. In operation this lead sits roughly 2.5 V above chassis, as Saab's 2010 9-5 documents for its wide-band probe; a wire touching the engine block, a bracket or the intake pipe drags it towards zero. The pump cell then has hardly any room to work, and both the measured oxygen share and the EGR rate derived from it become meaningless. Ford counts a grounded VM lead among the faults that set P0131 on its exhaust probes. No manufacturer documents P2AE7 itself, so this rests on CARB's range-check duty and the Bosch pin layout. P2AE6 is the open return, P2AE8 the high case, P2AE4 the low fault on the pump lead, P2AF0 bank 2.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / E7

Possible causes

  • Return lead chafed against engine or bracket high
  • Internal short of the common electrode to ground medium
  • Bias source in the ECM faulty low

Symptoms

  • Check engine light on
  • EGR cut back, possibly higher NOx

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2AE7

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication