P2AE5
Intake Air O2 Sensor Pumping Current Circuit High Bank 1
P2AE5 is the high-side fault of the pumping current lead on the bank 1 intake oxygen sensor. A short to the heater supply or another battery feed in the harness is the classic cause; because the intake sensor works in damp air close to where blow-by gas and EGR enter, water in the plug comes next. Ford files a pump lead touching battery voltage on its exhaust probes as P0132, while Saab's 9-5 (2010) uses the high code P2239 when the signal stays between 1.48 and 1.51 V for 1 s despite enrichment, a Type B fault. Neither applies directly to the intake, and no manufacturer documents P2AE5 publicly; CARB supplies the obligation to catch out-of-range inputs. A shorted pump wire can damage the sensor interface in the ECM, so measure before swapping parts. P2AE4 is low, P2AEE bank 2.
Possible causes
- Pump current lead shorted to the heater or another supply high
- Water or condensate in the sensor plug medium
- Sensor interface in the ECM damaged by the short low
Symptoms
- Check engine light on
- EGR reduced, NOx may rise
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2AE5
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.