OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AE4

Intake Air O2 Sensor Pumping Current Circuit Low Bank 1

P2AE4 flags too low a level in the pumping current circuit belonging to the bank 1 intake sensor, usually a pump lead chafed through to ground or an internal short in the pump cell. Saab's 2010 9-5 gives a useful reference for the same wire on its exhaust probe: about 2.8 V on terminal 1 at ignition-on with the sensor unplugged, and its low code P2238 sets when the signal stays under 1.7 V for 3 s on overrun. Ford instead stores a grounded IP lead as P0131. No maker documents P2AE4 for an intake sensor. Because the ECM can no longer pump oxygen through the cell, it loses the value it compares with the zero point learned without EGR, and recirculation is reduced or switched off. P2AE3 is the open lead, P2AE5 the high side, P2AED bank 2.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / E4

Possible causes

  • Pump current lead shorted to ground high
  • Internal short in the pump cell medium
  • Sensor interface in the ECM faulty low

Symptoms

  • Check engine light on
  • EGR reduced or switched off
  • Possibly higher NOx at an emissions test

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2AE4

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 2 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication