P2AE2
Intake Air O2 Sensor Pumping Current Trim Circuit High Bank 1
P2AE2 means the voltage on the trim lead of the intake air O2 sensor for bank 1 is too high. In the six-wire harness of a wide-band probe this line runs next to the heater feed, so a pinched wire or moisture bridging the pins in the connector can drag it towards battery voltage. Ford's 2012 OBD summary books a trim lead shorted to battery as P2628 on NTK probes and under the general high code P0132 on Bosch probes; neither covers an intake sensor, and no manufacturer documents P2AE2 publicly. CARB requires input circuits to be checked for values beyond their range in both directions. According to Bosch the trimming resistor fixes the sensor characteristic, so a falsified value shifts the oxygen reading that EGR control relies on. Check plug and lead against battery voltage before fitting a new sensor. P2AE1 is low, P2AEB bank 2.
Possible causes
- Trim lead touching the heater supply high
- Moisture bridging contacts in the sensor plug medium
- Internal short in the sensor or its connector module low
Symptoms
- Check engine light on
- EGR reduced, NOx may rise
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2AE2
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.