P2AE1
Intake Air O2 Sensor Pumping Current Trim Circuit Low Bank 1
P2AE1 is stored when the voltage on the trim circuit of the bank 1 intake oxygen sensor falls below its window. With the ignition on, the 2010 Saab 9-5 expects roughly 2.8 V on terminal 5 of its wide-band probe, the trim connection; a value near zero suggests a lead rubbing on ground or a shorted resistor in the sensor plug. Ford's 2012 summary shows how makers sort such faults differently: on NTK probes an open and a grounded trim lead (RL) both set the low code P2627, while on Bosch probes a grounded IA lead lands in P0131. No manufacturer publishes P2AE1 for an intake sensor. With the trim value missing, the EGR rate derived from the oxygen reading becomes unreliable, so recirculation is cut back. P2AE0 is the open, P2AE2 the high fault, P2AEA bank 2.
Possible causes
- Trim lead chafed through to ground high
- Calibration resistor in the sensor plug shorted medium
- Open trim lead on sensors whose interface reports it as low low
Symptoms
- Check engine light on
- EGR cut back, possibly higher NOx
Inspection / repair
- Difficulty: medium
- DIY: possible
What Pro shows you for P2AE1
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 2 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.
Sources
- saabwisonline.com/9-5-9650/2010/2-engine/engine-management-and-fuel-system-4-cyl-petrol/fault-diagnosis-diagnostic-trouble-codes/dtc-p2237-p2239-p2243-p2251-or-p2626
- newtonnet.co.uk/fiesta/fordobd2012.pdf
- bosch-motorsport.com/content/downloads/Raceparts/Resources/pdf/Data Sheet_69034379_Lambda_Sensor_LSU_4.9.pdf
- law.cornell.edu/regulations/california/13-CCR-1968.2