OBD-II reference

All 9.533 generic OBD-II codes, explained in detail.

Causes, inspection steps and sources — a comprehensive DIY archive. Created and maintained with love for the detail. Good luck and have fun!

Powertrain generic / SAE

P2AE0

Intake Air O2 Sensor Pumping Current Trim Circuit Open Bank 1

P2AE0 says the calibration (trim) wire of bank 1's intake O2 sensor has lost continuity. On a Bosch-type wide-band element this is pin 5 (RT/IA), which connects a resistor in the plug that Bosch uses to set the characteristic of each individual sensor; without it the ECM scales the oxygen signal wrongly. No manufacturer documents P2AE0 publicly, and no bulletin lists it. On exhaust probes Ford spots an open IA line (P2626) on overrun with the injectors cut: if the pumping current in pure air stays above roughly 3.1 mA for 2 s, the code sets. Saab's 2010 9-5 uses a 4.81 V limit in the same situation. Ford's EGR patent also learns the intake sensor's zero point at idle or during fuel cut, so a wrong air reading skews the EGR estimate. P2AE1/P2AE2 are low/high, P2AE9 bank 2.

SystemPowertrain
Typegeneric / SAE
GroupP2
Range / numberA / E0

Possible causes

  • Trim lead (pin 5) broken in the harness high
  • Trim contact pushed back or corroded in the sensor plug medium
  • Calibration resistor inside the sensor connector open low

Symptoms

  • Check engine light on
  • EGR reduced or run without oxygen feedback
  • NOx emissions may rise

Inspection / repair

  • Difficulty: medium
  • DIY: possible

What Pro shows you for P2AE0

Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.

  • Repair cost (estimate)(visible in Pro mode)
  • Labour time(visible in Pro mode)
  • 3 affected components(visible in Pro mode)
  • 3 warnings for driving and inspection(visible in Pro mode)

See repair cost, labour time and components?

One key opens all tools by Fabian Brose.

Already have a key? · What is the workshop key?

Sources

References

How to read OBD-II codes

The first letter names the vehicle system, the second digit distinguishes generic from manufacturer-specific, the remaining digits group fault area and number.

PPowertrain: engine, transmission, emissions
BBody: chassis trim, comfort, interior
CChassis: suspension, brakes, steering
UNetwork: CAN, control modules, communication