P2AD9
Reductant Pump Motor Position Sensor Circuit High
P2AD9 is the high-side fault: the pump motor position signal stays above its permitted range. An open signal line pulled up by the controller's internal resistor, a broken sensor ground or a short to the supply rail produce this picture. Without changing position information, speed control fails and the pressure build-up may be aborted; faults of the pump drive itself carry their own codes, in Ford's diesel summary for example P208A to P208D. No public document describes P2AD9 itself or its limit. Look for white DEF residue in the pump connector, since the fluid creeps along wires and attacks terminals, and check the ground connection before condemning the pump. A failure that stops dosing triggers the driver warning and, if ignored, the speed or restart restrictions of the SCR system.
Possible causes
- Open signal line or broken sensor ground high
- DEF residue corroding the pump connector medium
- Signal shorted to the supply rail low
Symptoms
- Check engine light and SCR warning
- No DEF pressure build-up, dosing stops
Inspection / repair
- Difficulty: medium
- DIY: shop recommended
What Pro shows you for P2AD9
Before you go to the garage: roughly what the repair costs, how long it takes and which components are involved.
- Repair cost (estimate)(visible in Pro mode)
- Labour time(visible in Pro mode)
- 3 affected components(visible in Pro mode)
- 3 warnings for driving and inspection(visible in Pro mode)
See repair cost, labour time and components?
One key opens all tools by Fabian Brose.